My sock drawer was a disaster. I had more socks without mates than not, and other miscellaneous "stuff" found their way in there too.
 |
| The before shot. Sad, right? |
First you're going to have to get some sturdy material to construct the dividers, I used a couple of plastic signs that I had put aside (used ones, so bonus recycling!) and also Contact paper to pretty things up.
I measured the drawer for inside length/ width and height, and decided how many cells I could get for the size of my drawer which measured 15" x 13" x 3", so I figured 5 cells going across and 5 down would be perfect.
So next, I set to work on the plastic board, I cut 4 strips for both sizes (15"x 3" and 13" x 3"), 8 strips in total.
And then I measured the half horizontal point on each board, and marked that in ink. I then marked my 4 points for the cells (15/3= every 3 inches, 13/5 = every 2.16 inches).
The next step was to cut the notches where I had marked for the cells, make sure you cut generous notches so the finished pieces fit together easily, like so:
Because I had some Contact paper leftover from another project I was able to cover the strips, and I found that the best way was to wrap the Contact paper completely around the piece, so both edges (upper and lower) would look finished; the ends of the strips did not matter so much because the would be tight against the inside of the drawer, so they are not visible. I felt with my fingers for the pre-cut notches and cut through the Contact paper.
Almost done, now to fit the strips together, I just lined up the notches and everything came together very quickly:
And here is the finished product! No more searching for socks, I know what I have at a glance and I will not collect any more socks than I have room for in the drawer. I think this is going to work well, so much so that I plan to do the same thing for my underwear drawer. Enjoy!
